Network (System Settings)
Dante Network Configuration
| Item | Description |
|---|---|
| Mode | Output is performed via a single cable when set to “Single Cable”. Output of IP control is performed via a separate cable when set to “Split”. Because this will require multiple connections, ensure that the necessary connections are made. |
| Latency | Set latency for the Dante port. |
Dante & Audio Port Settings
| Item | Description |
|---|---|
| IP Config Mode | Set the configuration mode for the IP address. When “Auto” is selected, IP addresses are automatically assigned by DHCP servers, etc. When “Static” is selected, static IP addresses are used. |
| IP Address[1] | Set the IP address. |
| Subnet Mask[1] | Set the subnet mask. |
| Gateway Address[1] | Set the gateway address. |
[1] This is possible when “IP Config Mode” is set to “Static”.
IP Control & Web Remote Port Settings
| Item | Description |
|---|---|
| IP Config Mode | Set the configuration mode for the IP address. When “Auto” is selected, IP addresses are automatically assigned by DHCP servers, etc. When “Static” is selected, static IP addresses are used. |
| IP Address[1] | Set the IP address. |
| Subnet Mask[1] | Set the subnet mask. |
| Gateway Address[1] | Set the gateway address. |
[1] This is possible when “IP Config Mode” is set to “Static”.
Allow Discovery
| Item | Description |
|---|---|
| Enabled | Set automatic detection for microphones on the same network. Setting to “ON” (blue) will enable automatic detection. |
IP Control Settings
| Item | Description |
|---|---|
| Port Number | Show the IP control port number. |
| Notification | Set whether to receive notifications from microphones during IP control. Setting to “ON” (blue) will result in notifications being received. |
| Audio Level Notification[1] | Set whether to receive audio level notifications from microphones during IP control. Setting to “ON” (blue) will result in notifications being received. |
| Camera Control Notification[1] | Set whether to receive camera detection notifications from microphones during IP control. Setting to “ON” (blue) will result in notifications being received. |
| Multicast Address[1] | Set the address for multicast. |
| Multicast Port Number[1] | Set the port number for multicast. |
[1] This is possible when “Notification” is set to “ON”.
Include in Setting file
Selecting the check box will apply the “Network” settings to the microphone settings when setting files are imported or when “App -> Device” is selected when connecting an online microphone.
|
|
|---|