Network settings

With the factory default setting, the IP addresses of the receiver (ESW-R4180DAN), mixer (with Audio-Technica LINK), and charging station are set to “Auto”, so devices are connected with IP addresses acquired automatically. To connect with static IP addresses, perform the following operations.

Using devices with static IP addresses

1. Configure the PC so that its IP address setting is acquired automatically, and then connect this PC to the network over Ethernet.

2. Start Wireless Manager.

3. Connect the devices and the PC on which Wireless Manager is installed.

4. Set each item under “Device Setting” -> “Network” -> “IP Setting” in Wireless Manager.

   • Set “Mode” to “Static”.
   • Assign a unique IP address to each device.
   • Assign a specific subnet mask to all the devices.
   • Check that the IP addresses of the devices meet the IPv4 setting standard.

   After the settings are changed, a message appears, and the devices are automatically restarted.

5. Change the PC to a static IP address, and then assign this IP address and the subnet mask.

6. Start Wireless Manager again.