Configuring links with the LINK button

You can use the LINK button on a charging station to configure the link to a transmitter. When suddenly changing to using a different transmitter where the link has not been configured due to transmitter malfunction, dead battery, or other reasons, the transmitter link can be configured without using the Wireless Manager.

• You have to set charging station port assignments in advance in Wireless Manager. Refer to Setting charging station port assignments for details.

1. Insert into the charging station the transmitter whose link will be configured.

2. Press and hold (approximately 3 seconds) the LINK button.

   • If charging stations are linked together, links will be configured to all the inserted transmitters when the LINK button on any charging station is pressed and held (approximately 3 seconds).
   • The power indicator lamp lights alternately in green and blue, and then the charging indicator lamp flashes.

   Status indicator lamp display	Link configuration
   Flashing in green (three times)	Registration success
   Flashing in red (five times)	Registration failure

	If you configure a link to a transmitter with the LINK button of a charging station, the transmitter will be registered to a transmitter area different from the normal transmitter area. If you linked to a transmitter using the LINK button of a charging station, the receiver registration that was originally registered for that transmitter will be deleted.

LINK button lock

You can use the “Link Button” setting under “Device Setting” to lock and disable the LINK button. Refer to Wireless Manager device settings for details on “Device Setting”.