Connecting Euroblock connectors

  1. Strip and wire the cable as shown in the diagram.

    • Do not solder stranded wires.

    1. Approx. 5 mm
    2. Approx. 20 mm

  2. Loosen the screws with a flathead screwdriver.

  3. Check the pin assignments and connect each cable.

    Terminal Pin assignments
    INPUT A (+: Hot)
    B (−: Cold)
    C (G: Ground)
    OUTPUT A (+: Hot)
    B (−: Cold)
    C (G: Ground)
    GPI A (1: GPI1)
    B (2: GPI2)
    C (G: Ground)

  4. Tighten the screws and use a zip tie to bundle the cables.

    • Use a commercially available zip tie.

  5. Connect the Euroblock connector to the microphone.