ATND1061DAN
General
| Power requirement | PoE (IEEE 802.3af Class 0) |
|---|---|
| Power consumption | Max. 7 W |
| Operation temperature range | 0°C to 40°C (32°F to 104°F) |
| Operation humidity range | 25% to 85% (Noncondensing) |
| Dimensions | 227.5 mm (9.0”) × 227.5 mm (9.0”) × 30 mm (1.2”) (W × D × H) |
| Weight | 1,250 g (44 oz) |
| Plenum rating | UL 2043 |
Microphone
| Beam width | 90° |
|---|---|
| Polar pattern | Beam pattern |
| Frequency response | 60 Hz to 18,000 Hz |
| Sensitivity | -8 dBFS (1 kHz, 94 dBSPL) |
| Dynamic range | 89 dB (A-weighted) |
| Signal-to-noise ratio | 61.5 dB (A-weighted) |
| Self-noise | 25 dBSPL (A-weighted) |
| Maximum input sound level | 102 dBSPL |
Analog audio
| Frequency response | 20 Hz to 20 kHz (+1.0/-2.0 dB) |
|---|---|
| Dynamic range | 100 dB (A-weighted) |
| Signal-to-noise ratio | 80 dB (A-weighted) |
| Headroom | 20 dB |
| Residual noise | -75.8 dBu (A-weighted) |
| T.H.D. | <0.1% (1 kHz, unity) |
| Analog input | MIC Maximum: -30 dBu MIC Unity: -50 dBu LINE Maximum: +12.2 dBu LINE Unity: -10 dBV, Switchable |
| Analog output | OUTPUT Maximum: +19.2 dBu OUTPUT Unity: +4 dBu/-10 dBV/-33 dBV, Switchable |
Other
| Network | Dante: 1 Gbps IP control: 100 Mbps |
|---|---|
| Digital audio | Sampling rate: 48 kHz Bit depth: 24-bit |
| Latency | Microphone (CH1 to CH6): 18 msec Microphone (Auto Mix CH in voice lift mode): 33 msec Microphone (Auto Mix CH in AEC mode): 50 msec Dante: Min. 250 usec, Max. 5 msec |
| I/O connector | Network/Dante: RJ-45 Analog input: Euroblock 3pin Analog output: Euroblock 3pin GPI: Euroblock 3pin |
| Phantom power | Analog input: 12 V |
| Included accessories | IR remote controller Surface mount adapter Screw (M4 × 50 mm) × 4 Flush mount adapter Flush mount cover Screw (M4 × 10 mm) × 12 Hole cover Nut × 4 Snap bushing × 2 Tile bridge A × 2 Tile bridge B × 2 Tile bridge C × 4 Seismic cable Zip tie Safety belt Euroblock connector × 3 Installation template |
- For product improvement, the product is subject to modification without notice.