Connecting Euroblock connectors

The Euroblock connector provided with the speaker is compatible with speaker cable sizes 18 AWG (0.823 mm2 (0.032"2)) to 14 AWG (2.08 mm2 (0.082"2)).

  1. Strip and wire the cable as shown in the diagram.

    • Do not solder stranded wires.

    1. Approx. 5 mm (0.20")
    2. Approx. 20 mm (0.79")

  2. Loosen the screws with a flathead screwdriver.

  3. Check the pin assignments and connect each cable.

    Terminal Pin assignments
    INPUT A (+: HOT)
    B: (-: GND)
    OUTPUT A (+: HOT)
    B: (-: GND)

  4. Tighten the screws.

  5. Connect the Euroblock connector to the speaker.

  • Be careful to prevent a short circuit between the positive (+) and negative (-) lines.